On the verge of giving up! Humidity problems.....

[Owen_]

i had never had the beads in there but it still read 70% but after a while i didnt trust anything so i just completely saturated the beads, threw them in and left it.

The ash isnt all that white and yes its as if the cigar is plugged, i thought this was from over humidifying the cigars yet like i say the band on the stick slides up and down and is really lose.

[badwhale]

Completely saturated beads isn't what you want. You want about a 50 /50 mix of white and clear beads.

Do you live somewhere that is extra humid? My stuff goes up in the summer here in Pennsylvania when it gets really hot and muggy.

[DanB6177]

i had never had the beads in there but it still read 70% but after a while i didnt trust anything so i just completely saturated the beads, threw them in and left it.

The ash isnt all that white and yes its as if the cigar is plugged, i thought this was from over humidifying the cigars yet like i say the band on the stick slides up and down and is really lose.

This may be the issue. I had similar problems of over saturating. Beads not only give humidity but they take it in (regulate) so should only be half wet. Also I found through advice on this forum that cigars must be in the box. You need to have those sponges in there to help the process. At the point you are at your box may be too wet. This is a spanish cedar box..yes? If your box is too wet you may have to take the beads out for a bit and dry the box again.
I actually bought a new humidor and redid the entire process. And I use the other box that I screwed up to throw my bands in

[ashauler]

Dry your beads until they are completely white........put them in the humidor and leave it alone for a couple of days, don't open it.
After a couple of days, check your beads to see if they are pulling humidity in and turning clear to one degree or another.
As mentioned above, keeping your humi somewhere around 75% full will help both to absorb RH and regulate normal fluctuations as you open / close it.
Above all, patience is the key. You don't want changes in your humidity to be drastic or fast.

[DanB6177]

something else i was thinking. How many beads did you put in the humi? You said you picked up two lots. For a smaller humi you dont need a ton of beads

[CoventryCat86]

Never mind...

I asked you where you live then found a previous post where you said you're from the UK. I thought your humidity problem may be a function of your climate however I see you've had this problem in the winter and the summer months in the UK. Your climate is essentially the same as mine in the northeast United States and in Nova Scotia so I don't think that's a contributing factor in your case.

Small humidors are like small salt water aquariums, they're a pain in the a$$ to regulate. It sounds like you have a fair amount of beads. How about trying to set up a small cooler as your humidor and seeing if you have any luck with getting the humidity to stay between 65 and 70%?

Just an idea....

Personally, I've never had a problem using beads but my humidors are located my finished basement where the humidity down there is almost 60% to 65% at all times. I have two large coolers set up with beads and I haven't added water in the past seven years.