Question regarding balance between humi temperature and RH level

[DB17210]

I would just use a spray bottle and spray them until most are clear. That is the easiest way.

Thanks. Do you have yours loose in some sort of container so that you can spray dirrectly onto the beads, dump them out of the tube, or spray through the tube?

[Mizicke5273]

I just spray the tube and bags.

[DB17210]

Thanks for the help guys! I think I got my beads dried out, and then re-saturated them w/only 4 teaspons. I only applied water (distilled) on about 3/4 of the surface area. I'm using 65% beads. Is it normal for the RH level to run high (around 70-72%) for a day or 2, and then drop down and level out? Thanks

[VancouverMark]

I have seen my 65% beads as high as 72% and then they drop down slowly. Once they my gauge reads about 60% I add some more water.

[DB17210]

I have seen my 65% beads as high as 72% and then they drop down slowly. Once they my gauge reads about 60% I add some more water.

OK. Great... I just wanted to make sure I didn't over saturate again.
Thanks

[Gern Blansten]

I have seen my 65% beads as high as 72% and then they drop down slowly. Once they my gauge reads about 60% I add some more water.

This is good info. Thanks for posting it. I'm not looking forward to our dry winters!