In a previous post I had a problem with uneven burn and found out that most likely cause was un-even humidification. Here is what I did:

I have an analog hygrometer that I calibrated with the salt test at a right on 75% and placed it in my humi since the humi came with an installed, non-removable, analog gauge. When the installed one read 70%, the calibrated one read 68%, so I was not too far off and had always kept the installed one at 70% or just slightly above/below say maybe 68-72. It has been stabilized at 68-70% for a little over two weeks now. I just use the humidifier that came in the humi with a 50/50 PG solution. I had to dry out some cedar pieces from some empty boxes and put them in to keep the Rh below 70% (also learned this here).

My uneven burn problems have gone away for the most part. Now I have noticed some splitting of the wrappers during smoking. This happens exclusively on my lighter shade cigars, (FdO gold and a Cusano 18 for example) but not with any of the maduro's. I researched here and on CP and read several posts that said it was due to over-humidification........then some that said the wrapper was drying out and cracking when smoking. RH ranges between 65 and 72 were suggested in various posts, right about where I am.

What should I do? Since I have way more maduro's and fuerte smokes than lighter smokes, should I not worry about it too much? Is it common to happen this way? Do I just need to let the lighter smokes rest longer before smoking?