Humidor from Waxing Moon With problems.

[mrtr33]

I spent about $1200. you will see I posted I spent $1220 + 160 in shipping on other post. I looked back and found I spent just under $1160 total. I state the correction on that forum. On others I state $1200. So I am $60 off.

Wait.....you're an engineer in Bitterville too?

The chip on the SC is not an issue, happens to most of the humidors, but, I usually catch it before it goes out.... it does not affect the seal, as the bevel itself is the sealing factor.... I have sanded the edges down as much as 3/16" before.... no problem there. A little 100 grit sandpaper will even it out and will not compromise the seal...

This sounds odd to me. I dabble in woodworking, and would never dream of using 100 grit on a finished product - not on the outside of a finish piece, anyways.

I wouldn't have handled this differently. I'm not quite sure why you think anyone here cares.......?

Cutting my thumb off didn't help.... it put me way behind and then I found myself rushing... which wasn't a good thing... but, nonetheless.... it happened.

That's funny right there.