I was bored again!

[illilli]

I love the young generation of geeks; they are big on showy and little on explanation. What caused that dip there on your little graph?

(I love it by the way....just so you know.)

[tc3driver]

I love the young generation of geeks; they are big on showy and little on explanation. What caused that dip there on your little graph?

(I love it by the way....just so you know.)

Slight bug in the code, Caused the firmware to freeze, thus was reporting the last temp and humidity, I bounced it at that time and uploaded new firmware to hopefully remedy the issue, there was another bug which I have zapped causing the other bumps that happened a few hours later. I hope I have got most of the bugs.

I may install some pressure tape to tell if the humidor is opened to explain wild shifts in humidity/temp, but I have yet to find any that is thin enough, so I may use conductive tape for that project. Those are next steps though.

This may be a base for an active coolidor controller that I am dreaming up... cooling, heating, fans, bead/sponge reservoirs, multiple inputs in different locations in the cooler, and some sort of logic to use the fans to keep the entire thing as even as possible. That is far down the road though.

[CptnBlues63]

Slight bug in the code, Caused the firmware to freeze, thus was reporting the last temp and humidity, I bounced it at that time and uploaded new firmware to hopefully remedy the issue, there was another bug which I have zapped causing the other bumps that happened a few hours later. I hope I have got most of the bugs.

I may install some pressure tape to tell if the humidor is opened to explain wild shifts in humidity/temp, but I have yet to find any that is thin enough, so I may use conductive tape for that project. Those are next steps though.

This may be a base for an active coolidor controller that I am dreaming up... cooling, heating, fans, bead/sponge reservoirs, multiple inputs in different locations in the cooler, and some sort of logic to use the fans to keep the entire thing as even as possible. That is far down the road though.

I like it too!

I run a Hyrdra-SM electronic humidifier in my humi. Could this be interfaced with it?

It would be cool to check my RH on my PC rather than have to go look at it all the time.

[tc3driver]

I like it too!

I run a Hyrdra-SM electronic humidifier in my humi. Could this be interfaced with it?

It would be cool to check my RH on my PC rather than have to go look at it all the time.

Thanks!

At this point I would have to say no, more because I would have to get one and take it apart to see if there are any interfaces that could be used for this purpose, or how much room there is to replace the guts with something that would work.

[CptnBlues63]

Thanks!

At this point I would have to say no, more because I would have to get one and take it apart to see if there are any interfaces that could be used for this purpose, or how much room there is to replace the guts with something that would work.

I may have to replace mine. It's been acting a little funny lately and not been keeping the RH at a nice constant level. When I saw your response I immediately thought about ordering a new one and sending you this one. But then I thought, "probably smarter to just by some Heartfelt beads instead". So now I'm undecided.

If the day comes I build a coolerador, I'll be contacting you to ask what hygrometer you used for this...