Here's an idea I have used......
Go to just about any dept store, craft store or hardware store and get a small roll of velcro strip. You can usually get a roll of about 24 inches or so and in a few different colors.
Take the soft loop portion and cut strips to fit the length of the divider sides. Don't kill yourself trying to cut the width yet.
Peel off the backing and stick the soft loop portion to the edge of the divider. Be sure that the divider edge is fairly smooth as the adhesive may not stick to a rough surface.
After you are sure it is well attached. CAREFULLY use an Exacto knife or a good SHARP razor knife to trim of the excess for the width or thickness of the divider. Cut the velcro loop from the soft side as cutting from the adhesive side is nearly impossible to do without royally screwing up the cut and also dislocating the strip. You can use the flat face of the divider as a guide to get a nice clean cut too!
AGAIN....please cut carefully. Take your time, (no running with scissors!).
Use black velcro loop. It looks best.
What to do with the plastic "hook" side of the velcro tape? Believe me, throw it away. It will only add clutter to your "everything" drawer!
Reply With Quote
Bookmarks